Bolt Anchor AN BZ3
Group: 1423
Anchor for push-through mounting in concrete tensile zones for M&E services and plant construction
High permissible loads with close edge and centre distances, suitable for cracked and non-cracked concrete under seismic loads of Categories C1 and C2
Simple and quick installation with matching drill diameter and drive-in hammer zone to protect threads
Overview of Types
General Information
Anchor for push-through mounting in M&E services and plant construction in concrete tensile zones. This anchor combines high permissible loads with close edge and centre distances. Suitable for anchoring in cracked and non-cracked concrete under seismic loads of Categories C1 and C2 and for use under fire exposure (R30–R120). For fixation of pipelines, channels, brackets, etc. in closed rooms - except for damp locations. For all other conditions according to EN 1993-1-4:2015-10, in accordance with the corrosion resistance classes (CRC) specified in Annex A3, Table TA2. No special drill required. Drill diameter is the same as the thread size. Simple and quick mounting due to its push-through concept. Drive-in hammer zone for preventing any thread damage.
Certification
Sikla Approval ETA-20/0611
VdS compliant for all sizes
Technical specifications
Primary element material | steel |
Surface finish | electro galvanized (Fe//Zn) |
Corrosion protection class | C2 |
Software
This product is available in the following software.
Installation
1. Drill bore hole according to the minimum bore hole depth perpendicularly to the surface.
2. Remove dirt from hole.
3. Drive the anchor into concrete up to its embedment mark.
4. Immediately resilient after tightening with the torque wrench T(inst) indicated in the table below. Advices of the mounting instruction are to be respected!